Samson Resolv SE Serie Manual Del Usuario página 5

Important Safety Information
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. This apparatus shall not be exposed
to dripping or splashing liquid and no
object filled with liquid, such as a vase,
should be placed on the apparatus.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation
openings. Install in accordance with the
manufacturer's instructions.
8. Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatuses (including amplifiers)
that produce heat.
9. Only use attachments/accessories speci-
fied by the manufacturer.
10. Unplug this apparatus during lightning
storms or when not in use for long peri-
ods of time.
11. Do not override the intended purpose of
the polarized or grounding-type plug. A
polarized plug has two blades, with one
wider than the other. A grounding-type
plug has two blades and a third ground-
ing prong. The wide blade, or third prong,
is provided for your safety. If the provided
plug does not fit your outlet, consult an
electrician to replace the obsolete outlet.
12. Protect the power cord from being walked
on or pinched, particularly at the prongs,
convenience receptacles, the point where
they exit from the apparatus.
13. Use only with the cart stand, tripod
bracket, or table specified by the
manufacture, or sold with the apparatus.
When a cart is used, utilize caution when
moving the cart/apparatus combination to
avoid injury from tip-over.
14. Refer all servicing to qualified service
personnel. Servicing is required if the
apparatus has been damaged in any way,
such as power-supply cord or plug break-
age, damage due to liquid
or objects falling onto the
apparatus, exposure to
rain or moisture, or if the
apparatus does not oper-
ate normally, or has been
dropped.
15. POWER ON/OFF SWITCH: For products
with a power switch, the power switch
DOES NOT break the connection from
the mains.
16. MAINS DISCONNECT: The plug should
remain readily operable. For rack-mount
or installation where plug is not acces-
sible, an all-pole mains switch with a
contact separation of at least 3 mm in
each pole shall be incorporated into
the electrical installation of the rack or
building.
17. FOR UNITS EQUIPPED WITH EXTER-
NALLY ACCESSIBLE FUSE RECEP-
TACLE: Replace fuse with same type and
rating only.
18. MULTIPLE-INPUT VOLTAGE: This equip-
ment may require the use of a different
line cord, attachment plug, or both,
depending on the available power source
at installation. Connect this equipment
only to the power source indicated on the
equipment rear panel. To reduce the risk
of fire or electric shock, refer servicing to
qualified service personnel or equivalent.