Technical Specifications - Scandyna The ball 2.1 Manual Del Usuario

The ball 2.1

Technical specifications

Power:
Shape:
Voltage:
LED light:
Inputs:
Outputs:
Drive unit:
Audio response:
Frequency:
L,R channel noise:
Sub channel noise:
L,R input sensitivity:
Sub input sensitivity:
S/N L,R (rated power): >70dB
S/N sub (rated power): >70dB
THD:
L,R audio separation:
Functions:
Remote control:
Protections:
The ball 2.1 remote control
Power Key:
Mute:
Master Volume:
Sub Volume:
REMARK:
4
40 Watt + 2 x 20 Watt Class D
Abs enclosure conceived to compliment the drop,
the Minipod or the Micropod SE
100-240 VAC
Power on, standby, mute, volume adjust
Stereo RCA Jack
Left-right for front speakers
6 ½ " long throw – 4 layer woofer
20Hz-20kHz
minus 3 db at 48 Hz, minus 6 db at 40 Hz
< 1.0 mv
< 1.2 mv
Input @ 1kHz 450mVrms @ rate power output
Input @ 1kHz 270mVrms @ rate power output
<0.3% @ 1 Watt, 1% @ rate power output
1kHz > 50dB
Crossover frequency adjust range 60Hz to 160Hz select,
digital volume control (360 dg type)
Master volume, sub volume, mute, on/off
Short-circuit protection, over current protection,
over temperature protection
ON, OFF (Power ON/ LED Blue light full,
Power OFF LED Blue light less bright)
ON, OFF ( Mute ON/ LED Blue Light blinking)
When adjusting the volume, the LED Light
will blink, until the volume is MAX or MIN.
When adjusting the volume, the LED Light will
blink, until the volume is MAX or MIN.
After 10-15 minutes without signal the ball 2.1
will go in standby mode/ LED Blue light les bright.
UK