Ideal AW 40 Instrucciones De Uso página 18

AW 40
A) Switching on/off
Pressing button A switches the appliance on.
Pressing it again switches the appliance off.
Button A is also used to start the Cleaning
mode. See section "Cleaning mode" (20 – 28).
B) Setting humidity level
The appliance is fitted with a hygrostat. This
measures the relative air humidity and
automatically switches the appliance off when
the desired value is reached. When switching
the unit on, the desired value is preset to 55%.
The desired value can be adjusted in steps of
5% by pressing button B. While selecting the
humidity output, the desired value is blinking.
The word DESIRED appears on the display
(F). The setting for the relative humidity ranges
from a minimum of 30% to a maximum of
70% relative humidity or "CO" continous mode.
A relative humidity of between 40 and 60% is
recommended. After a few seconds,
the display automatically changes to show the
current value (CURRENT) (F). Upon reaching
the desired relative humidity, the unit
automatically switches off (display shows
DESIRED and CURRENT) (F). If the desired
relative humidity falls, the appliance
automatically switches on again.
Quick display of current relative humidity
When the unit is switched off (mains cable is
connected), the current relative humidity can
be shown in the display by briefly pressing one
of the B buttons. This display automatically
goes out after a few seconds.
C) Changing the output level
The Air Washer can be operated on two output
levels. Press button C to select between
output levels Low "L" (night-time mode) and
High "H" (Normal mode). The chosen output
level is shown in the display by symbol G.
D) Change Ionic Silver Stick
The letter D in the display indicates that the
Ionic Silver Stick
The symbol remains visible until both B
buttons are pressed simultaneously and held
down for approx. 5 seconds.
E) Cleaning the appliance
The letter E in the display indicates that the
appliance must be cleaned. The symbol
appears as long as the cleaning mode is
activated or both B buttons are pressed
simultaneously and held down for
approx. 5 seconds.
F) Current/Desired Display
If DESIRED appears on the display, the
value in % next to it signifies the desired
relative humidity, i.e. the desired value
is shown. If the display shows CURRENT,
then the current relative humidity is shown.
H) Automatic switch-off
"Tank empty"
The water quantity is easy to see thanks to
the transparent water tank. The display on
the appliance also shows when the unit
should be refilled with water. If the water
level falls below the minimum quantity, the
appliance automatically switches off. A red
blinking symbol (H) appears on the display.
When water is added, symbol H goes out
and the appliance continues operating.
Warning: When lifting the upper part off the
base, the appliance also switches off. In this
case, the red blinking H symbol will also
appear on the display. Only when the upper
part is replaced on the base does symbol H
go out and the appliance continues
operating.
- 18 -
® (ISS)
® (ISS) must be changed.