Poulan ES300 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Right __Left
Hand
@@
• Position your left hand on the front
handlebar so it is in a straight line with
your right hand on the rear handle
when making bucking
cuts.
Stand
slightly to the left side of the saw to
keep your body from being in a direct
line with the cutting chain.
• Stand with your weight evenly bal-
anced on both feet.
• Do not overreach. You could bedrawn
or thrown off balance and lose control.
• Do not cut above shoulder height. It is
difficult
to maintain
control
of saw
above shoulder height.
KICKBACK SAFETY FEATURES
_WARNING:
The following features
are included on your saw to help reduce
hazard of kickback; however, such fea-
tures will not totally eliminate this dan-
ger. Do not rely only on safety devices.
Follow all safety rules to help avoid kick-
back and other forces which can result
In serious Injury.
• Hand Guard: designed to reduce the
chance of your left hand contacting
the chain if your hand slips off the front
handlebar.
• Position of front and rear handlebars:
designed with distance between ham
dies and "in-line" with each other. The
spread and "inqine" position
of the
hands provided by this design work to-
gether to give balance and resistance in
controlling the pivot of the saw back to-
ward the operator if kickback occurs.
• Reduced-Kickback
Guide
Bar:
de*
signed with a small radius tip which re-
duces the size of the kickback danger
zone. This type bar has been demon*
strated to significantly reduce the num-
ber and seriousness of kickbacks when
tested in accordance with ANSI B175.1.
Small Radius
Tip Guide Bar
• LowKickbackChain
hasmetkickback
performance
requirements
when
tested on the representative sample of
these chain saws specified
in ANSI
B175.1.
Low Kickback Chain
./Contoured
Depth Gauge
#z:;_l_._.4,---- Elongated Guard Link
_v-"
_
Deflects Kickback Force
And Allows Wood To
Gradually Ride Into Cutter
_!I_WARNING:
Computed
Kickback
Angle (CKA) listed on your saw and listed
in the following CKA Table represents the
angle of kickback your bar and chain
combinations will have when tested in ac-
cordance with CSA and ANSI standards.
Computed angles represented in the CKA
column indicate total energy and angle
associated without a chain brake. When
purchasing replacements, considerations
should be given to the lower CKA values.
In all cases, lower CKA values represent a
safer operating environment for the user.
• Tip contact in some cases may cause
a lightning fast REACTION, kicking the
guide bar up and back toward the op-
erator.
• Pinching the saw chain along the tip of
the guide bar may push the guide bar
rapidly back towards the operator.
• Either of these reactions
may cause
you to lose control of the saw which
could result in serious injury.
Do not
rely exclusively
upon safety devices
built into your saw.
The following guide bar and chain com-
binations meet kickback requirements of
CSA Z62.1 & Z62.3 and ANSI B175.1
when used on saws listed in this manual.
Use of bar and chain combinations other
than those listed is not recommended and
may not meet the CKA requirements per
standard.

Publicidad

Tabla de contenido
loading

Tabla de contenido