Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Operating and maintenance instructions for:
Chain Hoist PLM-NE and Lever hoist PLX-NE
I. Chain Hoist PLM-NE and Lever hoist PLX-NE
PLX-NE Lever-hoists are for pulling, lifting and tensioning, PLM-NE chain hoists are for
lifting.
The hoists can be attached to a trolley of any type as a travelling hoist.
Five prominent features:
1. Safety in operation with minimum maintenance.
2. High efficiency and small handpull.
3. Light weight and easy handling.
4. Fine appearance with small size
5. Durability in service.
II. Important indications
1. Read instruction and make it available to operators on the device before using it.
2. Operator must be instructed properly with the device. Never leave the device under
load unattended!
3. Never exceed carrying capacity indicated on the name plate. Do not draw any pull and
lifting ropes or chains respectively over angles.
4. Do not transport persons or loads with the product over areas below which persons
could be staying.
5. Device must be checked once a year by a technical expert, in case of harder operating
conditions more often. Ask your retailer or PLANETA. The enterpriser is liable in case of
damages and has to provide test certificates.
6. Check the device regarding damages, unfastened screws or twists before using it and
eliminate failures.
7. Repair works on PLANETA hoisting devices shall only be carried out by the
manufacturer or an instructed repair shop respectively by using PLANETA spare parts.
8. Check load carrying constructions, load securing devices, mountings, cross beams etc.
regarding load carrying capacity and condition of the required loads by a technical expert.
9. Non-observance of the instruction, improper use, and corrosion by insufficient
protection or product alterations without authority result in the expiry of the warranty.
10. Risk of corrosion in case of continuous contact with unfavourable atmospheric
conditions as for example high humidity or harmful environmental influences as for
example atmospheres with acid vapours, corrosive gases or high dust concentration
cause early wear. This effectuates no claim under warranty.
11. Further information or spare part lists will kindly be provided by us or your specialist
dealer.
- 9 -
Publicidad
