Publicidad
Idiomas disponibles
Idiomas disponibles
GB
III. Security advices
1. Read before use.
2. Do not overload
3. Do not work under a load
4. Never pull the chain over an arris
5. Never work with a damaged hoist
6. Never lift human with this hoist
7. Never throw the hoist
8. Do not wrap the load chain around the load
9. Never lengthen the lever
10. Never work up to the end of chain
11. Never attach the load on the tip of the hook.
12. Never work with a twisted or broken chain
13. Never work without a safety latch
14. Never remove the warning notice
IV. Assembly advices
A. Before initiation
1. Chain hoists with travelling trolley underlie the accident prevention regulation (UVV)
(Federal cooperative society regulations of Germany - BGV - D6). Before the first initiation
a quality inspection by a technical expert for cranes has to be carried out. Please contact
PLANETA for it. We will kindly advise you!
2. Never apply the chain hoist under -10 degree.
B. Installation and inspection before each application PLX-NE and PLM-NE
1. Hang hoist with the clamp into the load carrying system and turn once.
2. Hand chain and load chain must hang free and be without breaks or twists.
3. a.) PLX-NE Lever hoist: Operate mechanism for lifting and lowering and carry out load-
free test run with lifting and lowering.
3. b) PLM-NE chain block: Pull through hand chain one time completely load-free.
4. Inspection of load brake: Lift up lightly the load and hold it. If load is safe, go on lifting.
When lowering, the load shall not slide after hand chain shutdown or stop of the lever
movement at the lever hoist respectively.
5. If everything is performed properly, operation can be started.
6. Important for devices of multiple lines: Lower block shall not be snapped through the
chain loop. This can be recognised by a twisted chain. Each second chain link is in one
row not steadily in alignment. If the welded seams of the chain links are not in same
direction the lower block must be struck back through the chain loop.
7. The last chain link must be fastened on the cabinet.
C. Indications for the lever hoist PLX-NE
1. Chain freewheel must be switched off before lifting.
2. Do not lift a load simultaneously with several lever hoists.
3. Click sound of safety catch is normal when the load is lifted.
4. The brake grabs permanently – independent from traction direction (lifting or lowering)
Exception: In case of switched freewheel. – Never switch to freewheel under load!
5. Never hang on the rubber protection handhold!
- 10 -
Publicidad
