User Manual - SBS TEFB360 Manual De Instrucciones

4
UK

USER MANUAL

1. Pass the "WET" cloth over the screen
then dry the screen with the "DRY"
cloth. Next use the "black adhesive
sticker" to completely remove any
dust and other debris from the
phone screen. Be careful not to
leave fingerprints on the area to be
protected.
2. Open the "plastic lower applicator"
and insert it into the charging port
of your device after verifying which
connector (between the two) is the
correct one to use depending on the
model of your phone. For models
without a plastic applicator, use
the white adhesive included in the
package; place the screen protector
on the device, making sure it is
aligned with the holes on the screen,
stick the adhesive on the lower part
of the screen protector and on the
back of the phone, this will enable an
easy and accurate application.
3. Detach the entire transparent bottom
layer of the film to be applied, pulling
it from the side with the "Single hole"
at the top.
4. Place the coloured film with the two
small holes on the "lower plastic
applicator" and attach it by fastening
the "upper plastic applicator" onto it.
5. Use the spatula and, using an upward
motion from the bottom to top, press
the coloured film so that it adheres
uniformly to the phone screen.
6. Remove the top pre-cut part of the
white covering, pulling it from the
part with the "two close holes" in the
top right.