Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
4.
.
Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
Apply a high pressure spray to a small area and
then check the surface for damage
if no damage,
proceed to step 5.
Start at top of area to be rinsed, working down
with same overlapping strokes used for cleaning
Rinse
System After Every
Use
it is imperative that the chemical dispensing system be
rinsed after each use to prevent clogging or leaks:
1.
Fill System Rinse reservoir with clean water.
2.
Before disconnecting water supply, start your
cleaning system.
3.
Make sure black spray tip is installed.
4.
Rotate the Dial-A-Cleaner
TM
selector knob to letter
corresponding
to System Rinse tank. As clean
rinse water is drawn through the system, continue
the flow until no detergent foam is observed.
5.
Rotate the Dial-A-Cleaner
TM
selector knob to
the OFF position when finished
to prevent
chemical leakage.
Siphoning
DO NOT siphon standing water for your water supply
Contaminated,
brackish or dirty water can damage the
pump. Connect only to household water supply.
How to Use the Hose Reel
Your cleaning system is equipped with a hose reel
designed to store the hose when unit is not in use
See "Prepare Unit for Storage" for long term storage of
more than 30 days.
After each use:
1
Disconnect hose from spray gun and high
pressure outlet on pump.
2
Drain water from hose
3
Slide one end of hose into hole on hose reel. Turn
hose reel with handle to coil hose onto reel
IMPORTANT:
DO NOT use your cleaning system with
the hose coiled onto the hose reel. The hose reel is for
storage purposes only.
Tips
NEVER use garden hose inlet to siphon detergent
or wax.
If you hold the spray nozzle too far away from the
object being cleaned, washing will not be as
effective.
Always store the cleaning system with the Dial-A-
Cleaner
TM
selector knob in the OFF position.
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging the warm water onto
the ground.
11
Publicidad
Tabla de contenido
