Before Each Use; Pressure Washer Maintenance - Craftsman 580.752800 El Manual Del Propietario

BEFORE EACH USE
Check engine oil level.
Check water inlet screen for damage
Check high pressure hose for leaks
Check chemical tanks and filters for damage
Check spray gun and nozzle extension assembly
for leaks.
Purge pump of air and contaminants.
PRESSURE WASHER MAINTENANCE
Check and Clean Inlet Screen
Examine garden hose inlet screen. Clean if it is
clogged or replace if it is torn
Check High
Pressure Hose
High pressure hoses can develop leaks from wear,
kinking, or abuse Inspect hose before each use.
Check for cuts, leaks, abrasions, bulging of cover, or
damage or movement of couplings. If any of these
conditions exist, replace hose immediately
WARNING
NEVER repair high pressure hose. Replace it,
Replacement hose rating MUST exceed maximum
pressure rating of unit,
Check Chemical Reservoirs
Tank covers should snap cleanly onto tank. Ensure
chemical labels correctly identify tank contents.
Ensure that the System Rinse tank is filled with clean
water. Ensure that Dial-A-Cleaner
TM
selector knob
rotates freely between each position. Examine the
tanks and replace if the filter is clogged.
Check Gun and Nozzle Extension
Examine hose connection to spray gun and make sure
it is secure. Test trigger by pressing it and making
sure it springs back into place when you release it. Put
safety latch in UP position and test trigger. You should
not be able to press trigger. Replace spray gun
immediately if it fails any of these tests.
Check In-Line Filter
Refer to the illustration and service the in-line filter if it
becomes clogged, as follows:
In-line Filter
Nozzle
Extension
O-ring
1.
Detach spray gun and nozzle extension from high
pressure hose. Detach nozzle extension from
spray gun and remove o-ring and screen from
nozzle extension. Flush screen, spray gun, and
nozzle extension with clean water to clear debris.
2. Place in-line filter screen into threaded end of nozzle
extension. Direction does not matter. Push screen in
with eraser end of pencil until it rests flat at bottom
of opening. Take care to not bend screen.
3. Place o-ring into recess. Push o-ring snugly against
in-line filter screen.
4 Assemble nozzle extension to spray gun, as
described earlier in manual.
Purge Pump of Air and Contaminants
To remove air from the pump, follow these steps:
1 Set up cleaning system as described in the
"Assembling Your Cleaning System" and connect
water supply.
2. Pull trigger on spray gun and hold until a steady
stream of water appears.
To remove contaminants from the pump, follow these
steps:
1 Set up cleaning system as described in
"Assembling Your Cleaning System", and connect
water supply.
2. Remove nozzle extension from spray gun.
3. Start engine according to instructions in "How To
Use Your Cleaning System".
4. Pull trigger on spray gun and hold.
5. When water supply is steady and constant, engage
safety latch and refasten nozzle extension.
Nozzle Maintenance
A pulsing sensation felt while squeezing the spray gun
trigger may be caused by excessive pump pressure.
The principal cause of excessive pump pressure is a
spray tip clogged or restricted with foreign materials,
such as dirt, etc. To correct the problem, immediately
clean the spray tip using the tools included with your
pressure washer and follow these instructions:
Shut off engine and turn off water supply.
1.
2.
3.
4.
Remove spray tip from end of nozzle extension
Remove in-line filter from other end of nozzle
extension.
Use a small paper clip to free any foreign material
clogging or restricting spray tip
Use wire here _
to remove __
debris.
_
13