Beper RI113 Manual De Instrucciones página 11

Halogen heater Use instructions
WARNINGS:
1. Children should be supervised to ensure that they do not play with the appliance.
2. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
3. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
4. In order to avoid overheating, do not cover the heater.
5. the heater must not be located immediately below a socket outlet.
6. Do not use this heater with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
7. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
8. This heater in not equipped with a device to control the room temperature. Do not use this heater
in small rooms when they are occupied by persons not capable of having the room no their own,
unless constant supervision is provided.
9. There may be possible danger of installation close to curtains and other combustible materials.
PRODUCT DESCRIPTION (Fig. 1)
1- Carrying handle
2- Power switch
3- Protection grid
4- Halogen Elements
5- Radiant Panel
6- Base plate
7- Butterfly nut(2pcs)
8- Automatic power off
9- Power cord guide
10- Power cord
ASSEMBLY
Assemble the body frame and the base plate together as the following sequences:
Insert the supply-cord through the slot placed in the middle part of the basement and then assemble
the body frame to the base plate.
Secure the body frame to the base plate by means of the two butterfly-nuts. Insert the supply-cord
through the suitable slots and then fix it by the clamp.
OPERATION
Warning! Do not cover the heater during operation.
Plug in the appliance. Check that the outlet has at least a 220-240 volt current carrying capacity.
11