Cleaning And Maintenance - Marta MT-1174 Manual De Instrucciones

 Switch proper mode
 Wait for 35 – 45 sec
 Hang clothes on hangers or use trousers clip
 Take steamer and start operating
 Put thermal insulated glove on if necessary
 Use steamer frame for cuffs, collar and pockets
OPERATING MODES
1 – temperature 98С°, steam flow 14 g/min
2 – temperature 98С°, steam flow 35 g/min
FINISH
 Turn the modes switcher in off position, unplug from the mains
 Wait for 30 minutes to allow the appliance cooling down
 Pour the remaining water out of the container, remove the water drain valve. Make sure the

CLEANING AND MAINTENANCE

 Before cleaning, always unplug the appliance.
 Clean the device with a damp cloth, wipe dry.
 Clean the appliance from scale regularly. Use special cleaners that can be purchased at special stores. Applying cleaners, follow the instructions on the packaging.
TROUBLESHOOTING
Case
No steam
Weak steam or stream is interrupted
Cause
Device is not switched on
Watertank is empty
Steam hose is folded or deformed
Limescale inside the device
Small volume of water inside the
watertank or watertank is empty
Steam is not formed yet
appliance is empty.
Solution
Check connection with outlet
Switch off the device, cool , pour water
in watertank
Exclude the fold or deformation of steam
hose
Clean the device from calc not less then
1 time a year or every 50 hours of using
the device
Switch off the device, cool , pour water
in watertank
Pause is needed for the formation of
steam
8