Kenmore 146.46372610 Manual De Uso Y Cuidado página 28

Sideburner
10
□ Remove the sideburner grate. Loosen the burner in the sideburner shelf (B). To loosen, unscrew and
remove two front screws holding sideburner in place. (A). Note: Do not loosen electrode screw.
□ Remove the 2 pre-installed screws from the valve face and set them aside. (C)
□ Insert valve face stem through hole in fascia. (D) Attach bezel to fascia and valve face with previously
removed 2 screws. Attach bezel with black mark facing up (E).
□ Place sideburner tube over the valve, making sure that valve is inside sideburner tube.(F)
□ Push control knob onto sideburner valve face stem. (G)
□ Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace sideburner
grate. (H)
□ Connect both igniter wires to the igniter module on the underside of the sideburner shelf fascia.(I)
□ Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)
A
C
28•46372-407F0063
B