Pentair Water SunBrite II Manual Del Propietario - Operador página 6

Replace the lamp with a similar type and wattage. Failure to replace the lamp with the same type of lamp will damage the light assembly
and may cause an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock, and
may also cause damage to property.
Always install a new lens gasket (part number 79101601) whenever disassembling the light. Failure to do so may permit water to leak
into the assembly which could cause:
(a) an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock., or
(b) breakage of the lamp or lens, which likewise could result in serious injury to pool users, installers, or bystanders, or in
damage to property.
3. To remove light assembly, remove the special pilot screw at top of face ring, remove light assembly from niche,
and place assembly on deck.
Be sure to keep the special pilot screw from this underwater light. This screw mounts and electrically grounds the housing securely
to the mounting ring and wet niche. Failure to use the screw provided could create an electrical hazard which could result in death
or serious injury to pool users, installers or others due to electrical shock.
4. Disassemble light fixture and remove bulb.
a. For double-ended bulbs, push bulb towards spring loaded socket. When the other end of the bulb is clear of
the fixed socket, pivot the bulb out of the fixed socket and remove bulb, see Figure 2.
b. For 2 pin bulbs, pull bulb straight out of the socket. When replacing the bulbs in the 12-volt lights, ALWAYS
replace both bulbs at the same time, see Figure 2.
Be sure the power is OFF before installing or removing lamp. Allow the lamp to cool before relamping. This light fixture uses a Quartz
Halogen lamp. DO NOT touch the lamp with bare hands: This may severely reduce its life. Use the plastic furnished with the
replacement, a clean rag, or a tissue to eliminate fingerprints from getting on the lamp.
5. Install the new lamp(s).
6. Remove old gasket from lens and discard it.
7. Install new gasket during reassembly of light, Pentair Water Pool and Spa
Never operate the underwater light for more than 10 seconds unless it is totally submerged in water. Without total submersion,
the light assembly will get extremely hot and may result in serious burns or in breakage of the lamp or lens. This may result in
serious injury to pool users, installers, or bystanders, or in damage to property.
8. Secure ring to light fixture. See Section IV, Stainless Steel
Face Ring Assembly Instructions.
9. Replace light assembly into niche and tighten special pilot screw.
P/N • Núm/Pte. • Réf. 619692
WARNING
WARNING
WARNING
NOTE
Transformer required on 12 volt models.
WARNING
WARNING
6
P/N 79101601.
®
120 volt, Double-ended, Type T-3 R7S
12 volt, 2 Pin, Type T-3 GY 6.35
Rev C • Rev C • Rév C 10-29-07
Figure 2.