Before Use; Installing The Light - Briloner LIVARNOLUX 14125304L Instrucciones De Montaje

Safety / Before Use / Installing the light
Avoid the risk of fatal injury
from electric shock
Check the lamp for possible damage before
every use. Never use the light if it shows any signs
of damage.
CAUTION!
A damaged supply cable poses a danger to life
by electric shock. The device's supply cable can-
not be replaced. If the cable is damaged, the
appliance must be disposed of. The appliance
contains no parts which may be serviced by the
consumer.
Before use, verify that the available mains volt-
age corresponds with the required operating
voltage of the item (see „Technical Data").
Never allow the live power leads and contacts
to come into contact with water or other liquids.
Never open any of the electrical equipment or in-
sert objects into these. This will pose a risk of fatal
injury from electric shock.
Do not install the light on damp or conductive
surfaces.
Protect the product from sharp edges, mechani-
cal loads and hot surfaces.
Do not secure with sharp staples or nails.
Always unplug the plug-in transformer from the
socket before installation, removal or cleaning.
Never touch the plug-in transformer with wet
hands.
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
In the case of damage, repairs or other pro-
blems, please contact the service centre or a
qualified electrician.
Prevent fire and
injury hazards
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced.
If the LEDs cease to function at the end of their
operational life, the entire item must be replaced.
The installed LEDs are not suitable for
dimmers or electronic switches.
20 GB/MT
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instru-
ment (e.g. magnifier).
For your safety
Install the light so that it is protected from dirt
and excessive heat.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never use the light if you are having difficulty
concentrating or do not feel well.
Familiarise yourself with all instructions and
diagrams in this manual as well as with the
light itself before use.
To disconnect the lamp completely from the
power supply, the plug-in transformer must be
removed from the mains socket.

Before Use

Remove all packaging materials before first
use. Please remove the protective film
the light.
The light should not be connected to the supply
network while it is still in its packaging.

Installing the light

Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality
of the suction cups may be impaired.
Note: Ensure that a plug socket is located in close
proximity to the installation area.
Choose a suitable installation area
(mirror etc.).
Press the suction cup
surface.
Verify it is positioned correctly and securely.
Clip the light into the holder
1
cup .
2
Ensure that the light
from
8
onto the installation
2
of the suction
7
is positioned correctly.
1