Operation - Medel AIR Manual De Instrucciones

Filling the tank
• Lift the water tank and turn it upside down. A safety valve closes the tank.
• Open the screw cap of the tank.
• Pour the water. The maximum capacity of the tank is 2 litres.
• Tighten the tank tightly by means of the screw cap.
• Turn the water tank upside down and place it on the base. The tank must be stable on the base.

6. Operation

Note
Constantly check the degree of humidity of the air in the room. Intensive use can cause over-humidification of
the environment. Relative humidity should not exceed 60%.
Switching on the appliance
• Insert the plug into the socket and turn the knob clockwise.
• If there is no water in the tank or the level is insufficient, a red LED will light up.
The device turns off for safety reasons.
• Fill the water tank.
Fill the water tank as described in step 5. Start-up.
Note
The appliance is equipped with different emission modes:
to increase mist emission from minimum to maximum, turn the knob clockwise.
To adjust mist emission from maximum to minimum, turn the knob counterclockwise.
Turning off the appliance
• Turn counterclockwise.
• Pull the plug out of the electrical outlet
How to use the aromatherapy function
If desired, you can pour aromas and essential oils onto the insert inside the aroma compartment (3) to perfume
the environment. Do not pour the aroma directly into the water.
Follow the steps below to use the aromatherapy function:
- Pull out the aroma box (Figure 1).
- Use water-soluble aromatic oil and drip on the sponge (Figure 2).
- Put the aroma box back into the machine, the aroma function will
turn on automatically when the machine is switched on (Figure 3).
- To stop the aroma function or if the machine will not be used for a while.
Remove the sponge from the aroma box, clean it with mild detergents
and put it back in the machine.
100265_AIR_USER MANUAL_REV.00_22.07.19.indd 14
14
30/07/2019 16:11:46