What To Do In Case Of Problems - Medel AIR Manual De Instrucciones

• Leave for 2-3 minutes.
• Clean the ultrasonic membrane using the special brush.
• Rinse the base twice with clean water.
Internal cleaning of the base
• Soak a damp soft cloth briefly in an anti-limescale solution.
• Clean the inside of the base with the cloth.
• Carefully pour clean water into the base.
• Completely remove the anti-limescale solution.
• Repeat the procedure with clean water.
Removing limescale from the tank
• Fill half tank with water.
• Add a small amount of anti-limescale.
• Tighten the tank tightly by means of the screw cap.
• Turn over and shake the tank several times.
• Completely remove the anti-limescale solution.
• Repeat the procedure with clean water twice again.

8. What to do in case of problems?

Problem
No mist is released
Misted water has a strange smell
Loud noise
Misted water escapes from the base
of the tank
The red indicator light is on but the
tank is full
100265_AIR_USER MANUAL_REV.00_22.07.19.indd 16
Cause
The power cord is not plugged in.
The water level is too low, the tank is
empty.
New device.
Stale or dirty water.
The water tank is not properly fixed on
the base.
Water in the tank is insufficient.
The device is not stable and flat.
The water tank is not properly fixed on
the base.
Due to a malfunction, the appliance
incorrectly evaluates the water level in
the tank.
16
Solution
Insert the plug.
Fill the water tank.
Remove the tank, unscrew and remove
the screw cap.
Leave the open empty tank to ventilate
for 12 hours in a dry and cool place.
Empty the base and water tank and
clean thoroughly.
Fill the tank with clean water.
Remove the tank and place it correctly
on the base.
The tank must be stable on the base.
Fill the water tank.
Install the appliance on a horizontal and
fixed base.
Remove the tank.
Verify that the pass-way from the base
to the tank is clean.
If necessary, clean.
Place the tank correctly on the base.
The tank must be stable on the base.
Restart the device.
30/07/2019 16:11:46