H+H BS 38 Manual De Instrucciones página 13

Note: Mix the water thoroughly before measuring the water temperature
or put the thermometer in the tub while filling it. This will ensure a fast and
accurate reading of the water temperature.
- The display will read „COLD" when the measured temperature is below 33 °C. Bathwater feels
most comfortable at a temperature between 36.5 °C and 38 °C.
- Warm water alert: the red warning LED will start to flash when the measured temperature is
39 °C or above. The display will then flash „HOT."
The thermometer switches off automatically about 1 hour after its last use in
order to save the batteries.
REPL ACING THE BAT TERY
To replace the batteries, please proceed as follows:
1. Remove the battery cover located at the back of the measurement unit using a coin or
something similar.
2. Carefully remove the empty battery with a pair of tweezers.
3. Insert the new battery and replace the battery cover.
Please pay attention to waterproof ring position. It should be positioned as illustrated below.
SPECIFIC ATIONS
Measuring range:
Accuracy:
Display:
Battery:
Dimensions:
Battery life:
GUAR ANTEE
In the case of a defect, please return the device together with the purchase receipt and original
packing material to the point-of-sale.
0°C — 50°C (32°F — 122°F)
± 1°C (2°F)
LCD (display unit of measurement: 0.1°C / 0.1°F)
1x CR2032
40mm(L) x 43mm(W) x 53mm(H)
approx. 1 year (based on 1 hour of use a day)
non waterproof
13