D-Link DHP-1220AV Guía De Instalación Rápida página 3

PrODuCT SETuP
HARDWARE INSTALLATION
Before you can configure your DHP-1220AV for use, make sure the location being extended is on
the same electrical circuit. The diagram below shows an example of a Powerline network:
ROOM A
Internet
ROOM A
DHP-1220AV
Internet Modem
ROOM B
HomePlug AV
Device
Notebook
DHP-1220AV
Notebook
Your computer and DHP-1220AV are now connected. Please refer to "Setup Wizard" on the next
page to connect your DHP-1220AV with your existing Powerline network.
DHP-1220AV
ROOM B
DHP-1220AV
HomePlug AV
Modem
Device
Step 1
Plug the DHP-1220AV to a power outlet near your cable or DSL
modem and connect an Ethernet cable from the modem to the
INTERNET port on the DHP-1220AV.
Step 2
In the other room, plug your HomePlug device into a wall outlet in a
place you want to extend your network.
iPad
Step 3
Connect the included Ethernet cable to the LAN port on your
DHP-1220AV and to your computer's port. You may also connect
to the DHP-1220AV over Wi-Fi with the information on the Wireless
Configuration Card.
ROOM C
iPad
HomePlug AV
Notebook
Device
iPad
Notebook
3