Premier CH-4171V Manual De Instrucciones página 7

!
!
17. If the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer or its service agent.
18. Do not strike fireplace glass.
19. Always use a certified electrician should new circuits or outlets be required.
20. Always use properly grounded, fused and polarized outlets.
21. Always use ground fault protection where required by electrical code.
22. The heater must not be located immediately below a socket-out.
23. Always disconnect power before performing any cleaning, maintenance or
relocation of the fireplace.
24. When transporting or storing the fireplace and cord, keep in a dry place, free
from excessive vibration and store so as to avoid damage.
25. WARNING: In order to avoid overheating, do not cover the heater.
26. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
27. Children should be supervised to ensure that they do not play with the appliance.
28. Indoor and household use
29. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly switched on and
off by the utility.
!
!
!
INSTALATION
This section provides step-by-step instructions for installation of your
fireplace.
WARNING
The outlet must be 15A/125V.
CAUTION
1. This fireplace is designed to be able to hang on solid walls or insert into
a wall hole after proper construction. Select a suitable location, which is
not susceptible to moisture, safe, dust free, away from high traffic and
away from things may catch fire or block openings such as drapes,
furniture, etc.
2. The fireplace must be installed at a suitable position where at least
50cm above the floor and no higher than 180cm.
NOTE
It is a good idea to place your fireplace near an existing outlet,
for ease of electrical hook up.
CAUTION
Store your fireplace insert in a dry, safe and dustless place when
placing the mantel or building the wall construction.
WARNING
Do not attempt to wire you own new outlets or circuits. To reduce
the risk of fire, electric shock or injury to persons, always use a
licensed electrician.
1. If there's no 15A/125V outlet near the desired location, install a new one
near or behind mantel.
2. Make sure the fireplace insert is switched off (refer to operation
instruction section).
3. Plug the fireplace into a 15A/125V outlet. Wiring the cord along the
corner of wall.
*#! ! *$!