Premier CH-4171V Manual De Instrucciones página 9

!
!
B. Operation
On the first usage of remote controller, install the batteries first: open the
battery box by sliding its cover along the arrow, install two AAA batteries
according to the marks in the box, and slide the cover to its original
position. If no batteries installed or the batteries are failure, the remote
controller will be unusable to use the remote controller effectively, point it to
the electric fireplace and keep a distance of 1-5 meters.
There're four buttons marked the same as buttons on the remote controller,
each pair of them perform the same function, choose as you favour.
1. Power control. Press the <ON/OFF> button, the electric fireplace
will be powered on, and the lamp will brighten up. The heater will
not be turned on automatically when you power on the fireplace,
please refer to paragraph 3. Note, all operations are valid only
when the power is on, except to "turn the power on" operation.
Press the <ON/OFF> button again, the fireplace will be powered
off.
2. Adjust the brightness of simulated flame and logs. When the
fireplace is powered on, flame is turned on automatically, and it is
as bright as when the fireplace is powered off. Press <DIMMER>
button to adjust the brightness, the
the brightness of the flame and logs will start and keep changing.
When the brightness goes to the point you want, press <DIMMER>
button again, and the brightness will keep still and the
keep brighten up.
!
lamp will be flashing, and
lamp will
*'!
!
!
3. Flame speed adjusted control. Is defined as the stepper motor
speed control / on and stop. When the fireplace is powered on,
is brighten up, click <FLAME> to start a stepper motor speed
control loop, from between 20-7s and then click <FLAME> stop at
the current location, adjusted speed the process of
display (as dimmer lights flicker frequency ), do not adjust flame
speed then the is brighten up.
4. Press <HEAT> button, process of operations in accordance with
LOW-HIGH-OFF-LOW ... ... status, between the cycle of low-power
to high-power and then off. Press one <HEAT> button, when
micro-light is on low-power status. Another press <HEAT> button,
when full-time bright is on high-power status. Then press
<HEAT> button, when dark the heater is power off.
Note, before the heater emits heat or after it stop producing heat, the
hot air outlet may output air for 10 seconds. This is designed for
protect circuit, and it's not spoiled.
5. Power off the electric fireplace when you leave it for a long time.
6. The two alkaline battery must be removed from the appliance
before it is scrapped.
7. The alkaline battery is to be disposed of safely.
!
blinking
*(!