Canon RS-CL07 Manual De Instalación página 16

7
Hook the Base bracket to the Joint
fi tting and secure it temporarily
Hook the Base bracket on the protrusion (A)
of the Joint fi tting, and secure it temporarily
using the four supplied M5 screws (B).
Pull out the cables as shown.
Be sure to secure screws (B) tightly after making
the adjustment discussed in "Adjusting the
Projection Angle " (page 9).
8
Connect cables
1 Connect cables to the projector.
2 Affix the supplied Canon logo seal as
shown.
After completion of installation, adjust
the projection angle (page 9).
For SX7/SX6/SX60/X600/X700, affi x
an additional seal at the back.
B
A
B
5