General Guidelines - HQ-Power SOUND MACH II Manual Del Usuario

3. General Guidelines

• The VDSSM2 should only be used indoors with an alternating current of max. 230VAC / 50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture.
• Install the device in a well-ventilated area. Keep a minimum distance of 30cm around the device.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Fuse Installation
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are you will need to replace the fuse as well.
• Replace a blown fuse with a fuse of the same type and rating (15A / 250VAC 5 x 20mm, order code: FF15N for
the subwoofer / 10A / 250VAC 5 x 20mm, order code: FF10N for the satellite):
1. Unscrew the fuse holder on the rear panel with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten it with the screwdriver.
5. Description
Satellite rear panel
1. through
2. ground-lift switch
3. signal input
4. bass volume control
5. power input
6. fuse (10A)
7. power switch
Subwoofer rear panel
8. power switch
9. XLR and RCA input
10. through
11. gain control
12. frequency control
13. bass volume control
14. power input and output
15. fuse (15A)
16. pha 0-180°
VDSSM2 3 VELLEMAN