SKF TMBR Instrucciones De Uso página 5

3. Dismounting procedure
a) Clean the inner ring and aluminium ring.
b) Coat the raceway of the inner ring with an oil with following speciications:
• heat resisting 280
• heat transmitting.
• rust preventing.
• high viscosity.
c) Heat the aluminium ring to 280
For correct temperature control SKF advises the use of a thermometer, e.g. the SKF
Advanced thermolaser TMTL 1400K with surface probe TMDT 2-30.
d) Place the aluminium ring around the bearing inner ring and press the handles together
(or clamp locking device). Wait for a short time, then try to rotate the tool with the ring
until it comes loose from the shaft.
For mounting it is recommended to heat the bearing inner ring by means of a hot plate.
No open ire, as this might change the material structure.
SKF TMBR
C (536 F).
o o
C (536 F).
o o
3