Publicidad
1
100cm
This hand dryer has to be fixed at proper distance of at least 80cm
from a bathtub, or shower or washbasin.
1.
The hand dryer must be installed at 100cm above the ground.
2.
Use the fixing bracket to fix the hand dryer to the wall.
3.
Use the mounting template provided to secure the brackets to
the wall at 90cm above ground
4.
Fix the brackets to the wall using bolts and screws included in
the box
5.
Make the electrical connections.
Installation with cable and plug: The unit comes with power cord
and plug protuding from a hole in the rear and sliding along a
guide towards the bottom. The power outlet should therefore be
recommended at a distance of 0.5m from the bottom / right part
of equipment, at a height of 30cm from the floor.
Installation under track: You can remove the plug and use the
cable for wall installation without the warranty is void. When
installing cable in conduits use the following key measures for
preparing the electrical system, but using the template provided
for positioning the brackets.
Measures for preparation for cable track out below: Make the hole
in the wall at a height of 70cm from the floor. The hole should be
also 10cm right of central axis.
6.
Place the unit on the bracket.
7.
Pull out the water tank at the base of the dryer and drill the wall
in correspondence with the hole in the wallbase, as in the picture
below. Use one of the anchors and screw to secure the unit to the
wall, also using the o-ring washer for maximum seal between the
screw and plastic.
8.
At this point, you can turn on the power and use the
equipment.
Security System: The machine has an activation system that
prevents vandalism or continuous operation, caused by partial
coverage of the photocells. It will be enough to remove the cover
that obstructs the photocells, and it will make the dryer to resume
its normal function.
Maintenance: Warning - Before performing any maintenance
90cm
disconnect the device from the network.
Clean dryer with a soft cloth moistened with water and neutral
detergent. If present the HEPA filter, to ensure durability and reliability,
periodically check the filter and if necessary clean with a light jet of
compresed air not close on paper filtering. Do not touch filter paper
because you can damage it with your hands.
Its's necessary to empty the water tank regularly at least once a
week. The tank slips off after pressure from the behind part by a
button on the back.
If present the HEPA filter, follow the instructions to remove it by pulling
gently towards you without touching the filter paper. Then remove
the water tank to empty and replace everything. Be careful not to
wet the HEPA filter as this can compromise its effectiveness.
25cm
10cm
30,3cm
Publicidad
