CDVI DGA Manual De Instrucciones página 15

INSTALLATION MANUAL
DGA
Cast aluminium Digicode
to disable this function).
1] Enter the old user code:
- the relay is activated and the green LED lights on.
2] Enter the 2-digit sub master code (default sub master code A and B):
- the red LED lights on to authorize the modification.
3] Enter the new user code:
- the green LED lights during 1 second to confirm the new user code The red LED lights off.
4] Check the new user code to make sure of the modification.
SETTING A SUB MASTER CODE
The Sub Master code allows the user to change its own code without entering in programming mode. For
security reasons the code need to be changed periodically. This feature makes it easier and faster to change
its code
1] Enter the master code twice (12345 default master code):
- the red LED lights on to confirm entry in programming.
2] Press A7 to program a sub master code for the user individual Pin code modification of Group 1:
- the green LED lights on during 1 second,
- enter the new 2-digit sub master code,
- the green LED lights on during 1 second to confirm programming of the sub master.
3] Press A8 to program a sub master code for the user individual Pin code modification of Group 2:
- the green LED lights on during 1 second,
- enter the new 2-digit sub master code,
- the green LED lights on during 1 second to confirm programming of the sub master.
4] Press B to exit from programming:
- the red LED lights off to confirm exit from programming.
AUDIBLE SIGNAL
The audible signal is enabled in programming mode and when the relay is energised after a valid code. To
enable the audible feedback on a key press:
1] Enter the master code twice (12345 default value master code):
- 2 beeps are emitted to confirm entry in programming mode.
2] Press A twice:
- One beep is emitted,
- Press 0 to disable the audible signal during a keypress,
- Press 1 to enable the audible signal during a keypress,
- One beep confirms the modification.
3] Press B to exit from programming:
- 2 beeps are emitted to confirm exit from programming mode.
Self Contained
®
EN
15
cdvigroup.com