Hardware Installation - Conceptronic C300RC Manual De Instrucciones

ENGLISH

3. Hardware Installation

When the software for your 802.11N Client is installed, you can proceed with the hardware
installation.
Conceptronic C300Ri – PCI Card
A. Turn off your computer and disconnect the computer from the AC outlet.
B. Open your computer case by removing the screws from the back and remove the panel.
C. Find a free PCI slot and remove the protective plate from your computer case.
D. Insert the C300Ri gently in a free PCI slot and fix it with a screw to your computer
casing.
E. Close your computer case and assemble the 3 antenna's to the C300Ri.
Align the antennas like shown in the image below:
F. Turn on your computer.
Windows will detect new hardware and installs the drivers automatically.
Conceptronic C300RC – PC Card
A. After your computer is rebooted, insert the C300RC into a free PC Card slot of your
notebook.
Windows will detect new hardware and installs the drivers automatically.
Conceptronic C300RU – USB Adapter
A. After your computer is rebooted, insert the C300RU into a free USB slot on your
computer.
Windows will detect new hardware and installs the drivers automatically.
Note: You can use the USB Extension cable to move the USB Adapter for better signal
reception.
13