Material Supplied; Installation Dimensions - Bauknecht DDC 7750 Manual De Uso

MATERIAL SUPPLIED

Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps, activated carbon and grease filters installed.
• Instructions for assembly and use
• 1 collar
• 1 deflector
• 1 assembly template
• 2 washers
• 4 wall plugs Ø 8mm
• 4 screws Ø 5x45
• 6 screws Ø 3.5 x 9.5
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Note: The model with electric shutter can only be used in "Extractor version" and the exhaust pipe must be connected to a peripheral extraction unit.
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector.
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector.
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: check that air recirculation is facilitated.
If the hood does not have a carbon filter/s, order one/them and fit it/them before use.
Install the hood away from very dirty locations, windows, doors and sources of heat.
The hood comes supplied with all the materials required for installation on most walls/ceilings. However, a qualified technician is needed to make sure that the
plugs are suitable for your ceiling.

INSTALLATION DIMENSIONS

Note: The front panel is supplied as a kit to be purchased separately. The dimensions given refer to available standard kits.
Adjacent wall units
65 cm (gas or combi cookers)
50 cm (electric cookers)
Adjacent wall units
600 mm min.
Centre line
hob surface
GB12