General Safety Instructions; Special Safety Information; Overview Of The Components; Instruction Manual - AEG MC 4406 Instrucciones De Servicio

General Safety Instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• To avoid the risk of fi re or an electric shock, you should not
expose the device to rain or moisture. Consequently, do not
use the device in the immediate vicinity of water - for examp-
le near a bath tub, a swimming pool or in a damp cellar.
• Use the device only for the intended purpose.
• Only connect the device at a properly installed plug socket.
Pay attention that the specifi ed voltage corresponds to the
voltage of the plug socket.
• When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
• Assemble the device in such a way that the available
ventilation openings are not covered.
• Never open the housing of the device. Incorrect repairs can
constitute a considerable risk for the user. Should the device
become damaged, in particular the mains supply cable, do not
operate the device any longer, but rather have it repaired by an
expert. Check the mains supply cable regularly for damage.
• For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manufactu-
rer, our customer service department or a similary qualifi ed
person.
• If the device is not used for a longer period, remove the plug
connector from the plug socket or take out the batteries.
These symbols may be found on the machine and are intended
to indicate the following:
The lightning symbol should advise the user of parts
in the inside of the device which carry dangerously
high voltage levels.
The symbol with an exclamation mark should advise
the user of important operation or maintenance
instructions in the accompanying documentation.
Devices bearing this symbol work with a „class 1
laser" for tracing the CD. The built-in safety switches
should prevent the user being exposed to dange-
rous laser light, which is invisible to the human eye,
when the CD compartment is opened.
Under no circumstances should these safety switches be
bypassed or manipulated, as this could result in a danger of
exposure to the laser light.
Children
• In order to ensure your children's safety, please keep all pa-
ckaging (plastic bags, boxes, polystyrene etc.) out of their reach.
Caution! Do not allow small children to play with the foil as
there is a danger of suffocation!
• To protect children from the dangers posed by electrical
appliances, make sure that the cable is hanging low and that
children do not have access to the appliance.
44
05-MC 4406 AEG New4 44
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid
accidents and prevent damage to the machine:
CAUTION:
This refers to possible hazards to the machine or other objects.
NOTE: This highlights tips and information.

Special safety information

This device works with
a class 1 laser.

Overview of the Components

1 ON/STANDBY button
2 STANDBY control lamp
3 IR Sensor for the remote control
4 X-BASS button
5 VOLUME Λ / V buttons
6 Function selector switch
(CD/USB/SD / AUX IN / AM-TUNER / FM-TUNER)
7 USB connection
8 TUNING control
9 FM ST./MONO Function selector button
10 FOLDER UP button (album upwards)
11 CD compartment
12 OPEN/CLOSE CD compartment
13 LCD display
14 II (Play/Pause) button
15 I SEARCH/SKIP button (forward search)
16 I SEARCH/SKIP button (reverse search)
17 CD stop button
18 LINE IN Socket
19 FUNCTION Function selector button
20 Flap OPEN
21 PROG/CLK-ADJ button (memory/time)
22 SD/MMC Slot
Reverse Side
23 SPEAKER R/L Loudspeaker connections
24 AC Mains connection
25 FM ANT throw-out aerial

Remote Control

1 ON/STANDBY button
2 VOLUME - / + buttons
3 II PLAY/PAUSE (Play/Pause) button
4 STOP button
5 I / I SKIP/SEARCH buttons
(reverse search/forward search)
6 DN/UP FOLDER SKIP buttons (down/up album)
7 REP/RAN button (repeat/random)
8 CLK-ADJ/PROGRAM button
9 X-BASS button
10 FUNCTION Function selector button
31.10.2006, 14:39:51 Uhr