Master Volume Feature - GE 24991 Manual De Instrucciones

Master Volume Feature

Master Volume Feature
The Master Volume Feature allows you to select a
single device (TV or audio receiver) that the volume
control always controls. For example, the remote can
be in TV mode while the volume buttons control the
volume on your cable box instead of your TV.
Enabling the Master Volume Feature
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release desired device
button (TV, DVD, CBL) for the device
you wish to control the volume.
3. Press and release the
MUTE button.
4. Press and release the VOL + button.
The red indicator will blink twice and
then go off.
To test the feature put the remote in
another mode such as the TV mode if
you programmed the cable box to be the
Master Volume Device. Point the remote
at the cable box, press and hold either
the VOL + or the VOL - button. If the cable
box volume changes then the remote is
programmed correctly. If the TV volume
changes and not the cable box, you will
have to repeat the steps above and test
again.
Disabling the Master Volume Feature
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the device button
(TV, DVD, CBL) which is programmed
to control the Master Volume Feature.
11