Publicidad
Idiomas disponibles
Idiomas disponibles
Exhaust connection
4
Warning -
To reduce the risk of re or
personal injury:
•
This appliance must be exhausted to the outdoors.
Use only 4" rigid metal ducting for the home exhaust duct.
•
•
Use only 4" rigid metal or exible metal (semi-rigid or
foil-type) duct to connect the dryer to the home exhaust
duct. It must be installed in accordance with the
instructions found in "Connecting the Dryer to the House
Vent" on page 8 of this manual.
•
Do not terminate exhaust in a chimney, a wall, a ceiling,
gas vent, crawl space, attic, under an enclosed oor, or in
any other concealed space of a building. The accumulated
lint could create a potential re hazard.
•
Never terminate the exhaust in a common duct with a
kitchen exhaust system. The combination of grease and
lint creates a potential re hazard.
•
Do not use duct longer than speci ed in the exhaust
length table. Longer ducts can accumulate lint, creating a
potential re hazard.
•
Never install a screen in or over the exhaust duct. This will
cause lint to accumulate, creating a potential re hazard.
•
Do not assemble the ductwork with fastener that extend
into the duct. These fasteners can accumulate lint,
creating a potential re hazard.
•
Do not obstruct incoming or exhausted air.
•
Provide an access for inspection and cleaning of the
exhaust system, especially at turns and joints. Exhaust
system shall be inspected and cleaned at least once a
year.
This dryer is equipped with rear exhausting. If space
is limited, use the instructions in section 9 to exhaust
directly from the sides or bottom of the cabinet.
For straight line installation, connect the dryer
exhaust to the external duct hood using duct
tape or clamp.
External duct
opening
Duct tape
or duct
clamp
4" metal
duct cut
to proper
length
Duct tape
or duct
clamp
Installation instructions
19
Standard rear exhaust
(vented above oor level)
Recommended
con guration to
minimize exhaust
blockage
Leveling the laundry center
5
Level
front to
back
2 leveling legs
Leveling and stabilizing the appliance
1
Carefully move the appliance to its nal location.
Gently rock the appliance into position. It is important not to
damage the rubber leveling legs when moving the appliance
to its nal location. Damaged legs can increase appliance
vibration. It may be helpful to spray window cleaner on the
oor to help move it into place.
Note: Do not use washer cover to lift the unit.
To ensure the appliance is level and solid on all four legs, tilt
2
the appliance forward so the rear legs are o the ground.
Gently set the appliance back down to allow the rear legs to
self adjust.
3
With the appliance in its nal position, place a level on top
of back part of the washer lid and check it side to side, then
check front to back. Screw the front leveling legs up or down
to ensure the appliance is resting solid on all four legs (no
rocking of the appliance should exist), turn the lock nuts on
each leg up toward the base of the unit and tighten with
a wrench.
Note: Keep the leg extension at minimum to prevent excessive
vibration. The farther out the legs are extended, the more the unit
will vibrate.
ELBOW HIGHLY
RECOMMENDED
Level side
to side
Publicidad
