Operation And Controls; Filling The Water Reservoir - Nova 320170 Instrucciones De Uso

General
This complete NOVA Steam Station Plus
consists of a 220-240 V iron (50~60 Hz)
with a capacity of 1850-2200 W. The iron is
equipped with a separate steam generator.
The steam generator has a capacity of no
less than 1.5 litres, and is fitted with a
steam control to set the quantity of steam
to the required level.
The iron is equipped with a steam button to
give a shot of steam, and a temperature-
control dial to set the temperature to the
required level.
Operation and
controls
See Figure 1.
The appliance is equipped with the
following features:
1 Housing
2 Handle
3 Steam button
4 Temperature-control dial
5 Heel rest
6 Temperature indicator light
7 Soleplate
8 Connector with power cord and plug to
mains, and double-insulated power
cord and steam hose to iron
9 Steam appliance's control panel
10 Steam generator
11 Holder
12 Water reservoir
13 Limescale filter
• Replace the limescale filter at regular
intervals (see 'Maintenance and
cleaning').
Before use for the first time
• Use the iron solely for ironing.
• Always turn the temperature-control
dial to 'min' before putting the plug in
the wall socket or removing the plug
from the socket.
• Always take care when ironing in the
vicinity of children, and when children
use the iron. Never leave an iron
unattended when it is switched on,
even when the iron is standing on an
ironing board.
• Contacting hot metal parts, hot water
or steam can cause burns. Take care
when touching hot parts of the steam
generator and iron.
1 Before using the iron for the first time
verify that the mains voltage stated on
the base of the steam generator is the
same as your mains voltage.
2 Remove all labels and stickers that may
be attached to the iron.
3 Some parts of the iron are lightly
greased, and it is possible that the iron
will emit a little smoke when used for
the first time. This smoke will stop after
a short period of time, and is not
indicative of a defect.

Filling the water reservoir

• It is recommended that you fill the
water reservoir with a mixture of 50%
tap water and 50% distilled water. This
is particularly desirable in areas with
hard water, since this will prevent the
formation of excessive limescale.
• When refitting the water reservoir
make sure that the limescale filter's
tube fits exactly over the appliance's
suction opening. The appliance will be
unable to emit steam if the tube has
been fitted incorrectly.
Article 320170 Steam Station Plus
7