Installation Steps On The Isofix Platform; Removal From The Isofix Platform - Kiddy Evolution Pro 2 Manual De Instrucciones

EN

7.2.2 Installation steps on the Isofix platform

First the Isofix platform has to be properly mounted in the vehicle. For
this purpose, please refer to the instruction manual for the Isofix plat-
form.
Place the carriage in the foremost position. Slide the side releasing
slide at the knee of the platform to the back (fig. 16, no. 1) and pull the
carriage forward at the same time (fig. 16, no. 2).
Now place the Evolution Pro 2 from above onto the Isofix plat-
form, so that the locking bars are in the grooves of the platform
(fig. 17). If necessary, press the infant carrier down.
The green display's at the front and side of the slide indicates wheth-
er the seat is locked securely (fig. 18). If the green displays are not
visible this means that the Evolution Pro 2 has not been properly fas-
tened to the platform!
The final step involves pushing the releasing slide (at the side of the
knee) back (fig. 19, no. 1) and securely sliding the carriage at the pad-
ding of the vehicle seat's backrest (fig. 19, no. 2). Now let the releas-
ing slide go. The next locking position can be found by moving the
carriage.
The carriage must be securely locked and if this is the case, the green
display will become visible (fig. 19, no. 3).

7.2.3 Removal from the Isofix platform

To remove the Evolution Pro 2 from the Isofix platform, keep the
release handle for the infant carrier, which can be found above the
front cover, pull (fig. 20, A) and lift the infant carrier from the Isofix
platform (fig. 20, B).
Your Isofix platform is also equipped with a mechanism to release
the infant carrier. If you pull the releasing handle at the front of the
carriage (fig. 21, A), you can remove the seat in an upward movement
(fig. 21, B).
15