Assembly & Operation - Arrow EBN320 R.E.D. Manual De Instrucciones

ASSEMBLY
1 MAKE SURE YOU HAVE READ ALL SAFETY INSTRUCTIONS.
2 This tool comes completely assembled. There is no assembly required.
OPERATION
LOADING YOUR TOOL WITH NAILS
1. Unplug the nail gun.
2. Push down pusher assembly latch (figure a.) and pull back assembly to the stopping point.
3. The EBN320R.E.D.™ shoots 6 different size nails — 5/8" (15mm), 3/4" (20mm), 1" (25mm), 1-1/4" (32mm), 1-1/2" (38mm) and 2" (50mm).
4. Insert brad nails onto the track (figure b.). When correctly loaded, the nail tips will slide on the bottom of the nail channel.
5. Close pusher assembly and secure latch. This procedure moves nails forward into firing position.
6. Make sure the power switch is in the off position. Plug power cord into outlet. Now the nailer is in firing condition. Follow safety precautions.
figure a.
figure b. figure c.
figure d.
TO CLEAR AND CLEAN NAIL GUIDE
1. Unplug the nail gun.
2. Push down pusher assembly latch (figure a.) and pull back assembly to the stopping point, and remove any nails remaining in nail chamber.
3. Pull the nail guide cover latch down (figure c.) to release the nail guide cover.
4. Lift cover (figure d.) and clear the jammed nail.
5. Put the latch back and snap into its normal position.
BACK TO
INDEX
5