Go Rhino RC3 Instrucciones De Instalación página 10

INSTALLATION INSTRUCTIONS
Colocación del bracket principal
REV.01
STEP #1
1. Remove the lower front cover of the
vehicle
2. Locate the main bracket and auxiliary
bracket as shown in the image
3. On the top of the bracket place (1) 4 ½ x
1/2" screw, (1) 1/2" flat washer, (1) ½ "
lock washer and (1) ½" nut.
4. At the bottom of the main bracket place
(1) 1 ½ x 1/2"screw, (1) 1/2" flat washer,
(1) ½" lock washer and (1) ½" nut
5. Repeat the process on the other side of the
vehicle, do not tighten yet.
STEP #2
1. Align the skid plate with the holes of the
main and auxiliary bracket as shown in the
image.
2. Install using (2) 3/8 "screws, (2) 3/8" flat
washers and (2) 3/8" lock washers.
3. Repeat the process on the other side of the
vehicle, do not tighten yet.
© 2016 Go Rhino Products. All rights reserved
10