Descargar Imprimir esta página

Petra electric Perlfit PF 15 Instrucciones De Manejo página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
GB Instructions for use
Before using
Read these instructions carefully. They
contain important notes for the use, safety
and maintenance of the appliance. Keep
them in a safe place and transfer them to
a possible succeeding user.
Only use the appliance for the purpose
mentioned in these instructions. When
using follow the safety advice. Due to
sanitary reasons the appliance is excluded
from exchange after usage. When using
pay particular attention to the following
safety advice.
Safety advice
• When setting up the appliance the
safety advice has to be observed.
In Germany the VDE 0100-701 is in
force. In other countries consider the
national regulations (Fig. 1). For wall
mounting refer to separate instructions.
The blower unit must be set up above
the edge of the bath tub, with a lateral
distance of at least 60 cm.
For an installation at another place the
appliance must be set up at least 60 cm
from the bath and must be at a mini-
mum distance of 30 cm from the floor.
• The installation of protective gears
against fault current with a rated
breaking current of not more than 30mA
in the interior installation offers
additional protection. Also contact your
electrician.
• Set up the blower unit on a base at
ground level. Do not place or mount it in
the immediate vicinity of a heat source
and do not expose it to water or moisture.
Do not place anything under the blower
unit which could obstruct the air intake
slots in the base.
• Only connect the appliance to
alternating current - with a rated voltage
according to the rating plate - to a
correctly installed earthed socket.
Cord and plug must be dry.
• Only operate the appliance under
supervision.
8
• Do not move the blower unit when it is
in operation and do not pull the cord or
the air hose.
• Never operate the appliance from the
bath or with wet hands.
• Children are not aware or the dangers
that can be caused by electrical
appliances. Therefore never leave the
appliance unattended during use.
• Use non-foaming bath additives only.
• Do not disconnect the appliance by
touching it with wet hands or by pulling
the cord.
• If the following happens do not use the
appliance and unplug it immediately:
- the appliance or the mains cable is
damaged
- any defect after a plunge or something
similar is suspected.
In these cases have the appliance
repaired.
• Disconnect the appliance in these
situations:
- Any malfunction during operation.
- Prior to cleaning and maintenance.
- After use.
• Attention! The bubbling air is heated
before. Scalding danger exists with
intense contact to the skin outside the
water. The hose can heat up to 90
the connection field of the appliance.
• For cleaning do not immerse the
appliance into water.
• In the case of misuse, wrong handling
or incorrect repair no liability will be
taken for possible damages. Claims
under guarantee are also excluded in
such cases.
• The appliance is intended for private
use.
• In case the cord of this appliance is
damaged, it has to be replaced by an
authorised service agent of the manu-
facturer or a person having similar quali-
fications. Substantial dangers for the
user can appear from inappropriate
repairs.
Operation elements
Bathing period
With the control knob (Fig. 2) set the timer
to the desired bathing period. This will
switch on the blower unit and the heater,
and the red indicator lamp will light up.
The appliance can be switched off before
the end of the intended bathing period by
setting the timer back to 0.
Bubbling intensity
Set the switch on the air flow control valve
to the required bubbling intensity (Fig. 4).
Switch lengthways:
maximum bubbling intensity
Switch crossways:
minimum bubbling intensity
Operation
When setting up the appliance the safety
advice has to be observed.
In Germany the VDE 0100-701 is in force.
In other countries consider the national
regulations (Fig. 1).
For wall mounting refer to separate
instructions (with boring template). The
O
C in
blower unit must be set up above the edge
of the bath tub with a lateral distance of at
least 60 cm.
For an installation at another place the
appliance must be set up at least 60 cm
from the bath and must be at a minimum
distance of 30 cm from the floor.
Set up the blower unit on a dry nonuphol-
stered chair or stool. Moving furniture
should be avoided as the appliance could
fall into the bath tub.
Do not place anything, e. g. a towel, under
the unit which could obstruct the air intake
slots in the base.
Fit the plug in the bath. Wet the bottom of
the bath so that the suction pads grip well.
Lay the air bubble mat in the bath with the
hose connector at the foot of the bath and
press down firmly.

Publicidad

loading

Productos relacionados para Petra electric Perlfit PF 15