Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Starting up NVR
NVR CHANNEL CONFIGURATION BY MANUAL ASSIGNMENT
Here follow the step in order to add IP cameras to NVR channels using local Monitor:
1. Access the NVR OSD menu by pressing the right mouse button and enter the administrator password (default:
00000000), to check the firmware version that is currently installed in the NVR, access the menu page
"System" -> "Info". If the version is not recent, the NVR system software (firmware) can be updated by following
the instructions described in User Manual available in Urmet Web site (see QR code printed on the Addendum
sheet).
•
In the page "Main Menu" -> "Parameter" -> "Network" display the NVR current network parameters: wait about
ten seconds for assignment and automatic display of network parameters.
•
If the LAN network doesn't support the DHCP service, in the NVR page "Main Menu" -> "Parameter" ->
"Network" change from DHCP mode to "Static" mode, then manually enter the suitable network parameters:
IP address, Mask, Gateway, DNS.
IMPORTANT
To prevent video loss on the IP channels, make sure IP cameras have a static IP address configured.
The IP Camera Address can be changed from DHCP to Static using the button
2.
In order to add IP cameras manually and assign them in the LAN network to NVR channels, press the button
"+" as shown in the picture below:
DS1098-003
26
(see next steps).
Publicidad
Capítulos
