Starting Up Nvr; Nvr Channel Configuration; Important - Urmet 1098/800 Guía Rápida De Inicio

EN

Starting up NVR

NVR CHANNEL CONFIGURATION

Follow the steps below to add wireless cameras to the NVR channels:
1. Position the wireless cameras in required installation point and power them. Then power the NVR:
2. Immediately after being switched on, the NVR will start the automatic detection and
pairing process of the wireless cameras which are on. When the NVR detects a wireless
camera, the video stream of the camera will appear automatically on the NVR monitor.
The wireless signal level received by the NVR for each camera is indicated by the following icon
in overlay on the corresponding camera video (see following image, red circle):

IMPORTANT

In order to prevent loss of video signal, it is advisable to install the cameras and orient the aerials so as
to guarantee a stable wireless signal indication of at least two lines for each camera.
DS1098-001
20
visible