Singer ESP2 Manual De Instrucciones página 6

until the indicator light beneath the type of material you are going to press becomes
illuminated.
11. The Water Tank.
12. The Pressing Cushion is a fabric covered pad used for pressing gathered or
contoured areas such
13. The Measuring Cup is designed to assist you in easily and consistently filling the
Water Reservoir with the optimum amount of water.
14. The Spray Bottle allows you to moisten fabrics before pressing, helps to make the
pressing process easier and more effective in certain instances.
ABOUT THE AUTO SHUT-OFF
The Auto Shut- Off feature includes both an Auto Sh - Off and an Auto Wake-Up .These
multiple function safety features deactivate electrical power to the heater when the
Pressing Plate has been left closed against the Ironing Board for more than 10 seconds.
Heater deactivation is signalled by a beeping sound.Heater Functionality is restored when
the Pressing Plate is raised back up. Power to the heater will also be cut if the Pressing
Plate is in the raised position without use for approximately 15 minutes(once again signal
ed by a beeping sound) The heating ability of the unit can only be restored in this situation
by pressing the Temperature Control Buttons.
IMPORTANT: Auto Shut- Off does not mean that power to the unit is totally cut off.
Power is always on, and the Power Indicator Light will emain illuminated until On/Off
Switch is set to "Off"position.
FEATURES OF THE STEAM PRESS
Your Steam Press provides clean, professional results every time!
- Pressing surface is fourteen times larger than most hand-held irons
- Can reduce ironing time up to 50%
- Multiple dry and steam settings, burst setting to remove stubborn wrinkles
- Variable temperature control
- Automatic shut off safety feature while open or closed with audible alert
- Power indicator light
- Protects delicate fabrics like silk
IMPORTANT: For Household Use Only
Filling Instructions:
Do not plug the unit in until you have filled the Water
Tank
1. Place Digital Fabric Steam Press on a flat, level
surface.
2. Turn Locking Knob to Unlock position to unlock
ressing Plate.
3. Lift up Pressing Plate using Handle. It will
automatically stay in lifted position.
4. Pull Water Reservoir out. Note that Water Reservoir
cannot be completely removed from not attempt to
force it free.
5. Remove Water Reservoir Cap to express Water
Reservoir fill hole.
6. Using Measuring Cup(included), fill Water Reservoir
up to the MAX (300ml) line with distilled water.
7. Replace Water Reservoir Cap and push filled Water
Reservoir back into main unit.
DO NOT ATTEMPT TO PULL WATER RESERVOIR
OUT COMPLETELY.
4
struction Manual.indd 4 23.12.2011 15:25