Return To Factory Configuration; Performing Real Tests - hager S761-22 Manual De Instrucciones

Configuration

Return to factory configuration

Using this procedure you can change your remote-controlled socket back to its factory configuration and delete all
programming. Proceed as follows:
1) Start
If you make a programming error, the programming LED will flash quickly.You must carry out the programming sequence again
from the start.

Performing real tests

You can perform real tests to check your remote-controlled socket is working according to the selected configura-
tion. If a key does not respond, programme this key separately.
9
2) Press the key 3) Press once
9 times to select
to accept
delete mode selection
2
4) Press the key twice
to validate the return to
factory configuration
101
5) End
G
B