Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for selecting the Atlantic Pond & Garden Protector. Before using
this kit please take a moment to review this manual.
The Pond & Garden Protector can be assembled in an open area away from
the water garden. Once assembled, one person can easily lift the Pond &
Garden Protector to place it in its final location.
Recommended Use: Designed for leaves and light debris. Not designed to
carry heavy snow loads.
Assembly Instructions
Step 1:
Spread the Nylon Base out on the ground
in the shape of a rectangle. Make sure that
the base lays flat and that the sides are not
twisted. (Fig.1)
Step 2:
Assemble the fiberglass poles by inserting
the male end of one pole into the metal
connector of the next. The individual sections
of each fiberglass pole are strung together
with an elastic cord. This cord holds the
sections together once assembled. (Fig. 2)
Step 3:
Place the Center Pole Receptor in the center
of the Nylon Base. Insert the male ends of the
four poles into each of the four holes in the
Pole Receptor. (Fig. 3a) The poles should be
pointed toward the four corners of the nylon
base. If they do not point toward the corners,
rotate the Pole Receptor 90º. (Fig. 3b)
Step 4:
Starting at one corner, insert the end of the
pole (with the rubber cap) into the pocket
that is sewn into the Nylon Base. Repeat this
step for the other three poles. When making
the connection at the last corner, lift the pole
up as you insert it into the pocket. This will
2
Fig. 1
Fig. 2
Fig. 3a
Fig. 3b
Fig. 4
Publicidad
