Steren SEG-155 Manual De Instrucciones página 23

Change public pin
Press [3] + [4 digit pin]
When the public pin is 0000 it means that the code is empty in the "Card or Pin" mode.
Change door opening time
Press [2] + [TT]
TT is the time interval in seconds. For example, if the door opening time is 3 seconds, it will be:
TT = 03
Disable the door sensor alarm
Enable the door sensor alarm
After activating this function, the control will emit a continuous and prolonged beep when the door
is not closed, after it was opened normally, or did not open through the control.
Alarm delay time
TT is the time interval in seconds. For example, if the alarm delay time is 3 seconds, it will be:
TT = 03
This function will be performed when the door sensor alarm is enabled.
PIN Default: 1234
Press [8] + [0]
Press [8] + [1]
Press [82] + [TT]
8