Restore Factory Default - Steren SEG-155 Manual De Instrucciones

Restore factory default

Press [86] . You will hear 2 beeps, after 5 seconds enter to the configuration mode:
Press [*] + [Programming pin] PIN Default:: 990101 + [*].
Subsequently, the factory default values will be restored.
Card or PIN mode
The pins must be entered within 2 seconds, otherwise the system will be exited.
Press [*] to cancel the entered code.
Reset programming pin
Remove the control. Use a metal clamp to briefly connect Jumper 2 (J2), the control will emit a beep,
then 2 beeps, and the programming pin will be reset to the factory default (990101).
9