Faucet And Sprayer Installation - Westinghouse QL302 Manual Del Usuario

Installation (continued)

FAUCET AND SPRAYER INSTALLATION

Before installing, carefully unpack the faucet and ensure no
parts are missing .
1 . Insert the sprayer housing support through the
pre-drilled hole in the sink corner . Screw the nut onto the
threads and hand tighten .
2 . Run the sprayer hose down through the sprayer housing
and up through the centre faucet mounting hole . Connect
the sprayer hose to the faucet and tighten with a wrench .
Do not over-tighten .
3 . Install the faucet in the sink with hot water handle
(marked with an H or red indicator) on the left and cold
water handle (marked with a C or blue indicator) on the
right . From under the sink, thread mounting nuts and
rubber gaskets onto the faucet shanks and tighten the
mounting nuts .
4 . Connect the water supply lines (not supplied) to the
faucet .
Faucet shank
Mounting nut
Sprayer and hose
Water Supply Lines
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Faucet
Sprayer housing
support
Nut
CONGLOMKB .COM