RedHotDot Dent pulling inductor Manual Del Usuario página 7

It is recommended that you elevate the area you have been working on with the inductor. Raising the sheet
metal where the impact is, will stretch the metal in the opposite direction, which will avoid the dent
appearing again after it has cooled. The raised area will disappear after cooling. It might be necessary to tap
the raised area to acheive a perfectly flat surface.
After heating and correcting the dent, immediately cool the sheet metal with a cooling
spray or a wet sponge - it will freeze the new sheet metal form and stop it returning to
its original state.
Do not keep repeating the process, too much heat will lead to paint burn. Heated sheet metal needs to cool
down before reheating. Each time the sheet metal is heated and cooled, the dent reduces.
Whilst working on panels with multiple dents, the user must not work on one area, working in different
areas far from each other, allows the sheet metal to cool and will avoid permanent twisting of the sheet
metal (oil can effect).
Parts near the panel sides or corners are more difficult to straighten up, complementary PDR methods (Paint
less Dent Repair) may be necessary in some cases.
Parts with folds are more difficult to straighten up. The dent pulling inductor will reduce the dent but mastic
will be needed to get a perfectly flat surface.
FEATURES
Inductor dimensions (L x l x P)
Inductor weight only
Cable length
Date CE: 2016.
Dent pulling
inductor
9 x 3.5 x 3 cm
215 g
2.40 m
7
EN