Beper 70.401 Manual De Instrucciones página 10

Aroma diffuser Use instructions
Main parts description Fig.A
1. Nebulizer (in Main housing)
2. Water level float (in Main housing)
3. Water tank
4. Cap from the top of water tank
5. Mist output nozzle
6. Mist output adjustment button
7. Energy tower
8. Energy ring
9. Off LED light button (back of the unit)
Operation
Remove the cap from the top of the tank.
Fill the tank with tap water. (Don't add water exceed the energy tower.)
Add 3-5 drops of essential oil into the water.
Place the cap back to the top of water tank.
Plug in and turn on the appliance.
You can turn on/off the LED light by the Off LED button on the back of the appliance.
Note: Please don't add water exceed the energy tower.
It is NOT recommended to use the mist output at a maximum level at first, as this might spray too
much mist and a pool of water might form near the appliance.
Please start with a medium setting and adjust later to the desired mist output.
The humidifier has a safety system that switches the appliance off before it runs completely out of
water, due to the water level float. When the water will be almost depleted, the red LED will light on.
This safety feature is made to protect the nebulizer from being damaged due to lack of water.
To resume operation, simply switch off, refill the water tank with fresh water and place the cap back
on the main housing. Switch back on to start humidifier's function.
Cleaning and maintenance
Before any cleaning operation, switch the appliance off and unplug it.
-Always unplug the unit before cleaning.
-Remove the energy ring from water tank.
- Remove the energy tower from water tank by rotatting the power tower.
- Apart from the electrical controls and when the unit is off, any part of the humidifier may be wiped
with a soft damp cloth and buffed with a dry cloth, ensuring the unit is unplugged.
There may be some mineral deposits in the nebulizer, particularly if the water in your area is hard.
This deposit will influence the humidification process and decrease performance gradually. Please
clean the nebulizer with water and vinegar on a soft cloth regularly at least twice a week as follows:
1. Dampen a cloth with vinegar and wipe the nebulizer gently, until the mineral deposit disappears.
2. Rub down with a dry cloth and remove remains of humidity.
3. Do NOT rub the nebulizer with hard or abrasive objects.
4. Do NOT clean with chemical products.
Water accumulated over long periods may create bacteria and mildew (fungus).
-With each change of water the use is recommended to remove dust and any lime remains on the
nebulizer (preferably use a small soft brush, like a toothbrush)
- Water must not get inside the base part; should that happen, take it to an authorized service center
before using it again.
10