Installing The Product - MELINERA HG02411 Instrucciones De Montaje, De Uso Y De Seguridad

Foco láser solar
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
Note: In constant sunlight (depending on the season) the
drained rechargeable battery should take two to ten days to
charge.
Replace the rechargeable battery
improve after charging (Fig. B + C).

Installing the product

Install the product in accordance with Fig. A
1. Place the main unit
2. Insert ground spike
downwards.
3. Turn the joint screw
the lamp head
4. Tighten the joint screw
For optimal results, place the product in a location where the
solar cell unit
possible.
To adjust the angle of incidence, loosen the joint screw
position the solar cell unit
Then tighten the joint screw
Do not place the product under shrubs, trees, awnings, etc. This
will reduce the incidence of sunlight (see Fig. F).
Position the product so the solar cell unit
shaded.
Make sure the solar cell unit
sources, e.g. yard- or street lighting, or the light will not switch on
at twilight.
26 GB/IE
on to the pole
6
into the pole
5
counter-clockwise to adjust the angle of
3
as well as the angle of the solar cell unit
2
after adjusting the angle.
3
is exposed to direct sunlight for as long as
1
correctly.
1
3
1
if the light output does not
8
.
4
with the tip facing
4
.
is not covered or
1
is not impacted by other light
.
1
to
3

Publicidad

Tabla de contenido
loading

Tabla de contenido