VWR Thermal Shake lite Manual Del Usuario página 13

a) The digits of the TEMP display may be
reduced or increased by pressing "
or " " respectively.
The digits of the TIME display may be reduced
or increased by pressing "
respectively.
Press the above mentioned buttons for more
than 3 seconds to set up the exact value.
If the temperature should be set at 40°and the
time should be set up at 60:00, then press the
" " and not release to see the number
reducing; When the number shows 40, release
the button, and it will be automatically saved in
3 seconds. Next press the "
release to see the number reducing; when the
number shows 60:00, release the button, and it
will be automatically saved in 3 seconds.
Press "
c
reduce at a rate of 50rpm, release the button when the number reaches exact
value, and it will be automatically saved in 3 seconds.
When set up is done, press "
After the setting value of temperature is saved successfully, the device
will automatically heat or cool, to achieve the setting temp. point.
3 PULSE vibration
Press " " to start instant vibration or short term vibration. Press the button to
start it and release the button to stop it. The running speed of pulse vibration is the
highest vibration speed.
"or "
" or " "to set up for the speed. The number will increase or
"
"
" and not
"to start mixing.
10
TEMP
TIME
SPEE
TEMP
TIME
SPEE