Conceptronic CM3S Manual Del Usuario página 21

ENGLISH
Connecting the Audio Cable(s)
You can connect the unit to your TV and/or your home cinema system in 2 different ways:
- Analog, through the RCA Audio Jacks of the unit.
- Digital, Through the Optical Digital S/PDIF output of the unit.
Analog:
• Connect the Audio jacks (Red, White) of the Composite cable to the RCA Audio jacks [11 , 12] of the
unit.
• Connect the other end of the Composite cable to the RCA Audio Jacks of your TV or receiver.
Digital:
• Connect the Digital optical cable to the S/PDIF output [13] of the unit.
• Connect the other end of the Digital optical cable to the Digital optical input of your receiver.
Connecting the Power Supply
When the unit is connected to your Audio/Video equipment, you can connect the power supply to the unit.
• Connect the included power supply to the DC input [14] of the unit and to a free wall socket.
• Set the main power switch on the back of the unit to 'I' to power the unit.
The unit will now turn on.
Preparing the Remote Control
The remote control is using 2x AAA batteries (provided with the package).
You need to use the remote control to turn on/off the unit.
Notes: - The best operational range of the remote control is about 5 meters.
- Point the remote control to the IR receiver which is embedded in the front panel of the unit.
- The receiving angle of the IR receiver is ±30 degrees.
- Change the batteries (2x AAA) when they are weak or empty.
21