Special Maintenance Tasks - Sapphire Scientific DRIEAZ HVE3000 Manual Del Usuario

Monthly
Use an all-purpose silicone spray to lubricate wheels,
castors and latches. Take care to wipe up any excess
spray, as it may create slippery surfaces.
As needed
Replace HEPA filter. Replace when the filter is visibly
dirty. To access the filter, remove the filter cover plate
thumbscrews and lift off the plate. Replacement filters
are sold in packs of four. Ask for Dri-Eaz part no. F503
or Sapphire part no. 20-045.
Pump Inspection and service 1000 Hrs
Tools required
•
3/8 in. nut driver or socket with a 6 in. extension and a ratchet.
•
3/32 in. socket
•
15/16 in. open end wrench
•
Short handled screwdriver
Remove the cover assembly and inspect the recovery tank
for any remaining water. If necessary, wipe out the tank
with a towel.
Loosen hose clamp on float valve assembly and slip off
assembly.
Loosen cord clamp on inside wall of tank with the 15/16 in.
wrench, and pull in approximately two feet of cord or until
the cord shows resistance.
07-01782C F479/78-006
Warranty 07-01804

Special Maintenance Tasks

To ensure proper operation, we recommend the
following maintenance based on hours of use. In
excessively dusty or dirty conditions, it may be
necessary to perform these tasks more frequently.
Blower motor replacement
Order the motor brush replacement kit, Dri-Eaz and
Sapphire part no. S506. Complete instructions are
provided with the kit.
6
1000 hrs
Dri-Eaz Products, Inc.
Sapphire Scientific