Sapphire Scientific DRIEAZ HVE3000 Manual Del Usuario página 9

Using a Philips screwdriver, remove the pump intake cover
retention screw and the plate from the bottom of the pump.
Clean off any debris from intake area. Replace plate when
finished.
Wipe out tank with a clean rag.
Reassembly
Lower pump back into bottom of tank and fold handle down. Ensure that the pump feet are fully seated.
Replace pump rentention bracket.
Push excess power cord back through cord grip and retighten cord grip. The cord should be slack, but should not
hang down and interfere with the operation of the float or the float arm assembly.
Reinstall the float ball assembly.
Replace the cover assembly.
The unit is now ready to use.
07-01782C F479/78-006
Warranty 07-01804 9
Dri-Eaz Products, Inc.
Sapphire Scientific